The Jalopy Journal
Alright, I found steel backed aluminium alloy cam bearings that will fit a stock 292, the older version at least like my 1966. I am going to...
This helps a ton! :D Found a website (http://www.northernautoparts.com/part/cb-sh399s) that sells SH-399S kit, with SH-399 (position 1 & 4...
Its a 1966 292, and I have already checked on the cam and it is made for the 292.
Not yet, I haven't seen anything listed, but I am doing some ordering here shortly so I will give them a call.
I was hoping that had to do with sets being sold in different quantities for different engines. Hopefully they can chime in about aluminium...
Does anyone know off hand what the dimensions are off the cam bearings in a 292? My block is getting machined right now and can't check myself,...
About 15 PSi lol Actually I think PowerNation did a 292 and made 510ft.lbs on 10PSi. They had stock con rods though, I am planning to upgrade to...
Nope, someone swapped a 12 bolt with 3.73 gears from a 67-69 C10 at some point, and did so poorly. I put in a modern equivalent of the 14 bolt...
I am working on my 1960 C10 and originally planned to swap a 6.0 iron block (L96) built for boost and backed with a Magnum 6 speed. Yes, boo, I...
I have gotten a tremendous amount of information from this site over the years, but never had an account to ask my own questions or add my own...
Separate names with a comma.
The Jalopy Journal