The Jalopy Journal
Take the rings off First......................If Trim Rings are behind Caps you could use Narrow Rings that would Clear the Caps.
If you set it to DC volts would it not show the Draw ?
I call them Super DumbAss's, That's when Two Dumbass's Breed they Produce a Super Dumbass. This is caused by all the Safety Equipment used Today....
Didn't early Bronco's have Offset Booster?
Never heard of Warping Valves but I have Heard it will Speed the Flow up own the Exhaust Gases and that could be a Problem if Scavenging is...
Keeping original as Possible will always be Respected by me First and Foremost, but making Excuses for it or saying it's better than more modern...
It is Funny herein people compare 15000 volt ignitions to 40 - 60000 volt Ignitions. With Modern gas running Points is Ludicrous no matter how...
Motorized Fire Equipment, The fact that they Mentioned this lets you Know there was some Horsey's pullin Wagon's, and some Firemen smelling Hay...
1.5 OHM's for 6's and 8's, 3.0 OHM's for the 4's, will work like a Champ.
Is the Drums New, If they are, Probably need Turning to True Up........
I was Talking About the Housing of MC not the Fitting. I Have Put A Seat In Before by Filing down the Shoulder. The Fitting will not be Touched.
You can't File down the outer lip till Desired Depth is achieved for the Fitting?
Well from my Recollection there should be a Ballast Feed wire to the Coil in the Run Position from the Switch.
Separate names with a comma.