The Jalopy Journal
Everything is back up and running - thanks for everyone's input. I replaced the adjustment screws on the fingers - ensured they are now all the...
Thanks Mac! I hadn't thought about the play between the forks and the carrier. Truly appreciate your insight!
The "notch" must have been dirt or grease. The bearing is clean and smooth now. Thanks!
OK, update on this one: the throwout bearing carrier got spun 90 degrees and locked up with the clutch engaged. So, I got to pull my engine and...
Honky tonk hardwood floor by Johnny Horton Rock Around With Ollie Vee by Buddy Holly Rocket 88 by Jackie brenston Rocking Pneumonia and the...
Thanks all! Gives me a couple places to start digging in!
Need your input on a clicking noise when I engage / disengage my clutch (see video and be sure to have audio on). No noise when clutch is fully...
Thanks for all the info. Center PV have been run through lathe to square up the radius on the inside curve so washer fits snug. Secondary PVs...
Hi all. Still learning about flatheads and Holley 94s - thanks for all the great posts here and on Fordbarn. I have a 3x2 setup with Holley 94s...
Thanks for everyone's help and insight. I pulled the fronts springs apart and they were pitted really bad. Instead of trying to salvage them and...
I've also read really good things about Stant. I've got a pair on order. My t-stat is just wedged between top of header and bottom of the pipe...
Thanks for everyone's help! Here are some more pix of front end. Front x member appears to have original shape (not flattened). There is probably...
Thanks all! Appreciate the ideas. Will pull the spring this week and either put the placeholders on top, or re arch it, or both. Great idea...
Separate names with a comma.
The Jalopy Journal