The Jalopy Journal
But the next morning after I tripped over all the beer cans on the floor I relized it was not the motor I was trying to put in. it was the garden...
Beer!
It might not add any width to the rear end over what the break drum already has added. depending on what rotor you will be using the worst case...
And while running the engine the rear end was up on jack stands to turn the drive line
Oh no it was running for a while in the driveway for a good 20 min before we did the vidio
no it is hyd.
That was my son taking the vidio and just turned 16 I hope he didn't drink my beer LOL All though I would have LOL
hope that works
http://www.youtube.com/watch?v=xD4lPEL8ruw
Just thought I would share this with everyone because I really needed it. [MEDIA]
If your just replacing the pinion seal just remove the yoke nut and if your luky the pinion will just tap off.And at this point the seal is right...
Just south of Grand Rapids in Byron ctr just off 131 I will try to be at auto rama but funds are low and unemployed .
Well its like dating a fat chick,at first its ok but when she starts to shed some weight and tones thing up its a little more to handle and a lot...
sorry posted it to soon the 450cfm carb from holley is for a tunnel ram set up.they are mech not vacume sec,
Separate names with a comma.