The Jalopy Journal
3.36 sounds like a 10 bolt gear. Should be 3.31 in a 12 bolt. I would double check before I spent the money.
From the research I have done so far I can use the distributor from any rochester setup. I wont need the tach drive though but an old cable drive...
Bought a 57 Nomad last weekend that came with a 58 fuel unit that I would like to install. Missing the distributor. Any one have a line on one...
1957 Belair 4 door sedan with lots of extra parts. Has an original power pack 283 with a swapped in turbo 350. Engine turns over but haven't...
bump
Very rough 55 Chevrolet 2dr sedan. Has 327 with 1 double hump head and 3 speed manual with hurst shifter. Has seat springs for front and rear...
To remove the front pump take all of the bolts out of it and look for two holes that have threading in them. Thread two short 3/8 coarse thread...
I think the speedway will fit. The first set I had had clearance issues with the steering box in the stock location. The coated ones I bought fit...
One owner 69 Camaro RS/SS 396 4 speed car that had been tapped on every corner by drunk owner over the years but totally stock for $600 in 1984....
Liking the looks of this build. From the positioning of your engine I am thinking the Hooker big block Chevy 2 headers would probably fit. Two...
Very very cool!!! Diggin the paint and slot wheels. Can't wait to see this one cleaned up and going again. What brand are the wheels? I can't...
We snagged a 65 409 out of a c80 Chevy truck a few years ago and have a 65 dated 409 well engine. Really good buy for $100 especially if it came...
Take your torch and some water with you and remove the wheel and just cut a circle just outside the center hub through the brake drum. Works...
Separate names with a comma.