The Jalopy Journal
When you get around to putting it into an early Ford you might consider motor mounts like I used in my AVATAR. I was advised to use the original...
The good news is if the gasket is missing you should be able to tell by looking. Also did you remember the shims that allow for the thickness of...
Any chance someone forgot the gasket between the block and the flywheel housing and the oil is coming out from the rear of the cam? Charlie Stephens
I am not sure of the market for 4 door sedans in Australia. I am in California. I decided I wanted one about 30 years ago. Looked all over for...
If you go with a '32 K member here is how I set my brakes up using '32 pedals. Master cylinder fills through the cutout for the battery. Charlie...
Just a couple of thoughts. I think would use the early Ford pickup steering (contact Randy Gross, [email protected], 714-292-8660) over on...
Please accept my sincere apology, I was only looking for more information to give you a better response. I have trouble working with only part...
Looks good. Being a banger guy with vibration concerns I used the stock motor mount to get the rubber. Do you have any rubber in yours? Charlie...
What engine and transmission are you going to run? If I remember correctly guys like to use the rear end from a Ford Bronco to get the 5 on 5 1/2...
This may be what you are looking for. The original was cardboard but most of the reproductions are fiberglass. There is a layer of insulation...
There must be a Pontiac Club, have you tried them? Charlie Stephens
If it was mine I would put on bent spoke Kelsey's. What did you have in mind? Charlie Stephens
Sounds like a great idea. Replace that small 200 cubic inch 4 banger with a massive 136 cubic inch V8 and get more horsepower. Wait a minute???...
I am sure you know this but it is good to point it out. Frequently when a hub is run loose a crack will start in the axle. In time this crack...
I always liked the "Bent Spoke Kelsey wheels of that period. V8 hubcaps are available from Bob Drake. Charlie Stephens [ATTACH]
Separate names with a comma.