The Jalopy Journal
Well I just about have the front end tubes finished. Mr. Bruce I am thinking of welding some plates on either side of those tubes were they pie...
Well just got 1 upper rail bent and placed now I have to fit it on the lower and the front axle mount I hate pie cuts they take forever and I...
I just got the lower rails bent and fitted. More of pain than I thought it would be but there is no tension on either rail so I guess the bends...
The front axles in in place
OK Today I got my cross mounts fitted and anchored. As you can see with the pinch bars on the bottom you can level and square it up to the back...
Well I was able to re-do my seat uprights and made to carbon fiber seat work,I will run my front seat mount in the morning and tie everything in...
My first recommendation is get a machinist level before anything. You will thank me later>
This evening I made my steering box mount as well as the swing-out cross bar. Both came out good and looks pretty cool. Going to work on the...
39 Mr. Bruce kingpin boss to boss
Tell me what your settuong up rearend trans and block and I will tell you what I did
Today started working on setting up the front axle, bearings,seals and wheel. All went pretty smooth. I had to do a little machining on the...
Well today was kind of a half watching the Saints and working on the seat. I have got the carbon fiber seat to work in the chassis but I am going...
Well I got the roll cage almost complete. STREAMLINE TUBING included. Mow I will run over to Boogie Scott's shop in the morning and have him make...
Streamline has its benefits and looks great in the roll bar, I have just never fitted it before. But after 2 cigars, and a little cussing and a...
OK I want to know which one of you sick, twisted, sadistic chassis builders came up with the idea if fitting streamline tubing in the roll bar? I...
Separate names with a comma.
The Jalopy Journal