The Jalopy Journal
more of the rear sheet metal and wheel tubs in
pics of frame
forgot pic last post
crossmember and x bracing installed today
been workin on the hot rod just havent been keeping up with my pics on here here is where i am on it. Built a new rear clip so it will go LOW!!!!
forgot to mention look carefully at the trans mount the camaro t-5 is mounted on the bellhousing at like 14 degree angle. I had to fab up an...
got the trans mount in today just need to angle cut the excess on the 1x3 and plate the open end
Been a while since i last posted. Here are a few pics.
thats too bad i will have to make my own adapter hmm maybe there will be enough demand for these to make a few this is a wc transmission that...
picked up a t5 trans from a v6 camaro today after getting it home i did more studying to only find out this case is the ford bollt pattern i was...
my project billy o
well i am happpier with this slant back rather than the roll pan i had in it, it makes the rear real low.... the look i am after. here are a...
ok so was not a big fan of the roll pan so i changed it all the floor boards and rockers are in cut the wheel tubs out gonna raise them up i...
some more pics
Separate names with a comma.
The Jalopy Journal