The Jalopy Journal
Ebb is right shortening the rods doubles the amount of work and makes any replacement more difficult, add in the angle change and you have a no...
[IMG] 53 Commander - Morrison frame - Willwood - PS - 9" Posi - LS3/4L60 & more All new floors - Power window kits - Painless - Ididit -...
[IMG] [IMG] Dads last project - 1960 Ford Pickup - 1/2 ton with flat bed. 390 V8 with c4 Automatic transmission Removable side rails. Current Ca...
Rotella T oil
350 head on low side
A V8 J.A.P. or Flat head V8 with Ardun heads? For an exposed motor or pre war hot rod. Twin turbo AMG V8 or V12 if there's room. For a post...
I use a MIG welder and build up a flush or recessed bolt and weld a nut to the stub. Often takes more than one try.
Cornelius here, I do electrical! :^)
A single plane manifold is not going to give good mileage. A spread-bore carb on the stock 4brl manifold should work well. Port injection would...
LED bulbs?
150 @ Charlotte Motor Speedway
Make one from Teak or Burl wood!
http://www.msdignition.com/instructions/Products/Tech_Info/frm28371_coil%20compability.pdf
A blower motor without a blower is a dog. AN NA motor with a blower is a time bomb. If you want a blown motor build it and put the blower on it....
Separate names with a comma.