The Jalopy Journal
I used 49-53 truck pedal set changed the clutch shaft to later type with a frame mounted pivot, no lever on the trans
Ex Wife
I tried mine and they worked the same however I clamped them down. I pulled the plugs and dumped and rinsed out the old crud and put in some new...
Dick Spadaro, search on here or fordbarn, often has the not reproduced stuff, NOS that areard to find.
'46 Subframe cutoff, put in backwards, locate determined after engine is correctly placed, cake, just have to make front of X to avoid starter,...
Like ol don says, I put my radiator behind the crossmember made room from there back, no cut firewall, back axle ends up where it ends up.
Like charlie said and the same number on the side of the driver side of block, then you use that VIN and if there is no red flaq when you go to...
41 Ford tonner, need to take a hammer to it, think someone missed a spot
2 things I notice, the fan mounted on the crank, thought it was exclusive to big truck. Also usually the oil filter is on the rear of the heads,...
pre-49 = 59 cast on bellhousing, cam cover distributor? distributor sticking out top, bolt on bellhousing heads say 8BA for car 8RT for truck...
8BA is car although no big deal, still a flathead but no clean out pan unless someone swapped heads. Carb should be a 94 series and have 8BA or RT...
Yeah git it, 8RT will say so on the heads, bonus if it is a floor shift light duty 78 series trans. If it,s a HD trans still good scrap after...
Save rear trans cover /trans mount, saddle, ujoint and even the squirrely pedals and master cyl. mount, you just never know... Vin # is on the...
MY machine guy thought leaving the bearing out was OK, I took out about 18 3/4", tested to 70 mph and smooth and I don't do over 50 so OK for me....
Leatherman
Separate names with a comma.
The Jalopy Journal