The Jalopy Journal
Maybe check out this thread - might be as close as you find to your Buick...
No offence to anyone, but stay away from airbagit.com. I have bought numerous kits from thorbros.com. Regardless of where you buy, stick with name...
Found this link on google: http://www.plumbingsupply.com/brass.html About half way down, they are called face/flush bushing, but limited selection...
I have come across steel versions of those with electrical conduit, specifically around explosion proof and rugged/environmental boxes and...
On my 60 Buick, I used a rear end from a donor 74 Monte Carlo, arms and all. I cut the lower brackets off the diff and swapped them side to side...
For electric fans, I believe the best location for the sensor is in the rad - that is where the coolant you are cooling is. If that is not...
Don't get buried by the details! I installed one of these on every setup I have had a hand in, just to get home in the event of a problem. I...
Reality is though, your pressures may not be where you left them after a couple of days!! Best to compare tank measurements to figure out what...
Not familiar with Helix compressors, but that is a small tank for front and back. You may not get more than a single lift with that size,...
Wouldnt mind picking over that 53/4 Pontiac - where abouts is this?
I always set my personal cars up to lay out, but as I start to do work for people who have no experience at all with air ride, and some for...
Personally, I would say 8 valves for sure. Any time you tee anything you have the opportunity to get roll. If you want to run only 2 switches,...
My 62 LeSabre.
My oldest two the day I brought home my Olds. They advised me on the best way me unload it off the trailer and then helped me hose out the inside...
I seem to think that for the master cylinder you mentioned that the output for the rear to and from the proportioning valve will be 1/4. It will...
Separate names with a comma.