The Jalopy Journal
There's a guy in Phoenix that could probably help if you can't find someone closer. I would need to dig up his contact info.
Dan has been out of the Winfield adapters, plans to make more in the future but no schedule yet. I offset the seats like that in my Speedster,...
Here's a shot of the part Neil Jern made to adapt the Ford water pump to Olds/Chevy. For this project I will be using a low mount water pump so...
That’s a Burns intake with Winfield bolt pattern. Here’s a picture of the stock Olds rockers for reference… [ATTACH]
Gathering parts for a winter project... Olds 3 Port Head, Nash rockers, and Winfields. [ATTACH]
We used to spray the tanks in early Porsche 911s with Wurth SKS, which is similar to bed liner. It is done more for abrasion resistance than...
If the engine is newly rebuilt the rings may not have broken in yet, creating the excessive blow by. Just add a copper scouring pad inside the cap...
Beth Piranio is having yard sale today and tomorrow for anyone in the Denton / DFW area. Should be some interesting parts from the shop...
Van Pelt still sells the worm gear. I heat it up with an induction heater and pop it off with a gear puller using a big washer on top of the gear...
Contact Steve Serr for the gasket and a set of his ARP head studs for the Cragar head.
That's probably the old Continental Diesel thrust washer that was commonly used before the AER stuff came along. I'm away from the shop right now...
Once you have a brake, you're going to want a shear so might as well keep an eye out for both. I ended up buying a Mittler Brother's box and pan...
I use the Preval system when I'm too lazy to clean the jamb gun.
Yes, Monte Vista Colorado dirt drags will be back at Movie Manor next year. I'm pretty sure the dates are listed in the events section. This will...
To add to the above video, most old timers would drill a small hole at each end of louver and cut the slit between them. This will keep the metal...
Separate names with a comma.