The Jalopy Journal
Got the trim removed from the ftont fender and door, now I now have removed armrest, side trim under side window, and the panel held on with 6...
56don, seems if I can slide them off then I would have to cut them off with high speed. Does it mess up the stainless when you did this? Or is...
Johnny, thanks for the reply, yes the two remaining trim moldings on the fender? Do you have to remove the fenders?
Getting ready for paint prep after some chips appeared, how do you get the belt line trim off front fender? Also what about aft of door any...
Just curious what year is your T5, as I also looking at flathead with the T5. I have a 39 trans but seems not good under pressure from what I've...
Ok looked at your build , fine work what did you use to cut the frame?
Ok nice work, great frame repair, how are you cutting the frame, Plasma? Cutting disk?
I used cut off blade on die-grinder, and a saw with blade took a while with .100 thickness. Going to change from .023 to .030 thickness on wire...
[ATTACH]
Tried to make it work, but had to cut the seam, spread it out to were it should be, ordered the inner piece, plan on cutting out the rear quarter...
Have a 8BA flathead and also 59AB, I was taken apart and (I am new to this) seems fuel use the same flange as the oil pump. Can someone square me...
So people spend 4-600 for a motor only to find out it could be no good? I will take pan off and check end play on crank. How many motors till you...
Separate names with a comma.