The Jalopy Journal
Lets get this to someone that will use it. $300 ***edit: INTAKE IS SOLD!!***
Thanks, I have drilled and retapped to 1/2” not then plugged. Good to go now!
Well it appears it was cast in there since the bottom has a bit of a floor. Looks like counter bored and tapped. Anyone know what it could have...
Hey all! Hope the winter builds are chugging along! I have a fenton intake I picked up years ago. Just dug it back out and noticed that one hole...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Early Fenton 3 deuce intake. From a sbc, Good condition, should fit any small block chevy
Sorry , I guess it all does come into play, I need to add that I do have a 201 quick change I plan on using. And I do have a model a rear xmember....
I have a t-5 I’m going to use for the tranny. I was thinking the rear xmember would need to be mounted to accommodate the 35-6 rear spring...
yes, this is what I’m thinking. What tires are you going to run and were you able to use the stock hood or did you lengthen it? Also I have read...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] i have a lot of work to do..
This is what I was thinking I could use and was even curious to what y’all thought of roadster supply....
Thanks all, nice looking rides! I realize I need to cut the front cross member down width wise. But I haven’t been able to source one yet. I was...
Building a 30’ A on top of 32’ rails. I’ve got the just of the operation but still have a few unanswered questions. I have aquired the rear A...
Separate names with a comma.