The Jalopy Journal
Its a long story. Were some of the guys there from the car club that built it? Was it the River Rats or something like that?
Any of you guys there see the "Oly Rock" or hear the story about it?
Had a guy try to convince me to run this in our fleet trucks. http://www.wsbindustries.com/ Take a look at the engine oil additive. Never heard...
Head for Shedd every thursday afternoon to early evening. Just a bunch of good ole boys hanging out like it should be. Nothing fancy but worth...
Yea, I got a pair. They are usually in my wife's purse tho.
Truck driver says to the mechanic "I got a bad leak, I think I blew a seal" Mechanic says "I hope you washed your mouth out."
Yea, me too. Same thoughts on the car also.
Thanks for the suggestions. I will look into the blocks, just wasn't sure if the springs could tolerate it or not. I would like to achieve...
I looked at doing a z on the frame but it would screw up my cab mounting. The front hanger is just about at the back of the cab. I will take a...
The springs are 1 3/4" wide. Anybody have any ideas for springs? Seems like all the ones I see available are either 2 or 2 1/2 inches wide....
So another '35 IH pickup followed me home the other day. My plan is to run the full fenders and running boards. So the help I need is getting it...
Mickey Thompson did quit a bit with magnesium. I saw a SBC engine block made from mag in his daughters shop. Only two ever made by GM. I think...
Try this again. Picture didn't show up before. This was on the wall in the bathroom at a place in Spokane Washington called Milford's....
Don't remember any C-6 trans. Before the 727 was the earlier auto that was just an fmx. Almost all of the parts between the IH and Ford FMX...
Separate names with a comma.