The Jalopy Journal
That’s the same as Permatex #2. Been using it since I was a bubble gummer. That and 3M weatherstrip adhesive.
I avoid using any of the silicone...
Exposed gas cap.
‘50 has door.
Worn bushing/shaft will make the points gap/dwell go away.
Check for side play.
I have the gasoline heater option in my ‘62 Corvair. Fuel is fed from a ‘T’ in the pressure line from the fuel pump.
It also has an exhaust...
3M weatherstrip adhesive fixed a vacuum leak on this Stihl chainsaw.
I really, really don’t want to take it apart again.
I got to ask: Did you dump the load of dirt w/tree?
Good tinker project there. [emoji108]
331” hemi? No, no and no.
Because: There is no replacement for displacement.
And: You gain three circus fat ladies on the front bumper.
Drop in a SBC and sell the flat motor parts to one of the crazies on here.
Even a 265 is a vast improvement over the water boiler.
Coat the threads with Permatex #2. Black, sticky stuff. Never dries out. [emoji106]
A mechanic where I worked had a coil blow up on a fork truck as he was bent over the engine. His safety glasses prevented him from being blind....
The Desoto 341 in my Ford F100 hardly leaked around the plug tubes. All stock, tubes, grommets, washer and plug wire cover.
Lot to be admired...
Have you inadvertently limited the master cylinder to a too short of a stroke? [emoji2960]
Asking for a friend....................
Separate names with a comma.