The Jalopy Journal
Apparently my first attempt at lining up the rotor to the #1 cylinder was close enough! It fired up on the 1st try! Thanks guys for all your...
I'm replacing my old electronic ignition distributor with a new one piece, I've already marked "top dead center" and removed old distributor. How...
1964 Chevorolet Impala 327ci 350 Auto Tran I will be upgrading my failed Mallory Unilite Electronic Ignition (External Coil), with a ACDelco...
1964 Chevorolet Impala SS 327ci (Rebuilt) 25K Miles 350 Auto Tran AfterMarket Upgrade(s): Edelbrock exhaust manifold, 300 cfm 4bbl carb,...
Coil Reading this morning (Engine cold/) With the key on, voltage positive reads: 11.74 With the key off, voltage negative reads: 0.0 Battery:...
Mallory Parts: Coil: 29440 Distributor: 4748201 [ATTACH] [ATTACH]
The original problem was that the engine was starting and running fine for years, no issues. My original Mallory coil failed as did my optic...
yes, I'm running a ballast resister. When the ignition in the "off" position, I'm getting a 0.0 voltage reading on both positive & negative side...
Chevrolet 1964 Impala 327ci Mallory HEI With the ignition set to the off position, what type of reading should I get on either a voltage meter or...
Before trying the old cap/rotor (coil was replaced a year ago, so no old one), I started the engine in 90 degree heat with no issues, ran it for...
The coil is relatively new, however I understand that new parts can fail at any point in time. Is there a test or procedure that can validate a...
Separate names with a comma.