The Jalopy Journal
One I built, copied from a picture I saw somewhere.[ATTACH]
Try Roberts motor parts or Andy Bernbaum for Heater shut off valve. Did someone switch the oil pan?
Sorry for your loss. I lost my Dad 9 days ago. It's been rough.
If I remember correctly, at some point, possibly when they went from B series to C series trucks the oil pans went from rear sump to front sump....
[ATTACH] [ATTACH] This is a '47 truck block in my '56 but I think it would be the same.
[ATTACH] Nice Job! I did single stripes with a makeshift guide and found it difficult to match up at the start finish. Yours look great.
[ATTACH]
I don't know if this helps because this is a 241 , but there is no hole in this block at that location. If nothing else I'll get you back to the...
I seldom use it and definitely don't have a full grasp on the use of it but, it has all of the scales labeled and directions on the back. [ATTACH]...
If this is any help , I did a search on Timken's website L68149 comes up with a 1.3775" id.
1.The truck bellhousing will bolt to the Plaza engine 2. The truck flywheel will bolt up as there are 4,6,and 8 bolt patterns, but they...
Ahh.. you are correct my mistake.
Dodge Truck VIN Decoder at http://t137.com/registry/help/decode.php says its from a 1961-62 M37B1
If I remember correctly the starter drive retracts when the engine starts and spins it faster, so on the bench the drive pops out but doesn't...
If it's a 70's truck rear, which it sounds like, you also have to watch the diameter of the axle where you want to shorten it to. They are a...
Separate names with a comma.