The Jalopy Journal
Most enjoyable postings thanks
Thanks for the quick reply. Does it run well and accelerate well with these two carb's?
What size of Winfield's are you running?
If you are pulling the motor out you need to check the end play in the crankshaft. should be .002" If the flywheel housing was not dialed in so...
And some are still waiting for issues #84 and #85 to show up in the mailbox..........let alone #86
No; wooden mold, cope and drag with core for the internal runners.
I got it cast from permanent mold, also got single cast, to fit A through size D carbs.
When you set the position for the radius ball mounting, you should check the the castor angle is maintained to the original model A castor angle....
[ATTACH]
There are slots in the head of the bolts that are extending out of the bottom of the bellhousing. By removing the cotter key, the shaft in which...
Lingo head. 11 heads were produced. Searching on youtube John Lingo Ford model A. [MEDIA]
ford introduced the panhard bar in 1942. Cross steering in 1935.
yes 35 - 16" wires and lower the front end is a good start.
With spring over the axle if the thicker flange at the axle end of the radius rod is 1 1/8" thick and the other flange is 5/8" thick then...
If you are using conventional spring perches mounted through the axle then IMO you are wrong. If you are mounting the spring perches through the...
Separate names with a comma.
The Jalopy Journal