The Jalopy Journal
I doubt it will stay R-1. Pretty much everything around it is commercial. ITW (Fortune 100 company) has its corporate headquarters right across...
Got my Miller eNews today and they have an article on John Marcella with a bunch of short videos. Lots of hype on the equipment but there are...
To measure the pinion torque I took a six spline coupler and found a deep socket that fit snug inside then pinned it in place. I use that with a...
Looks nice. How about a photo of the finished car?
The local community college here starts off with gas welding and it's good for teaching fundamentals. Plus, learning how to control the torch is...
Someone did a pretty good tech article on rebuilding these a while back. Should be in the archive. It's not that difficult.
Check the project section on Miller welding website.
I always tell people to get the most welder you think you're ever going to need. If you don't, you end up wishing you did. I went with a...
So it's a hot rod lifestyle magazine with an article on the History of the Rat Rod in the first issue and an ad featuring Kim Kardashian on the...
Most of the Fords went for reasonable prices. Pretty much everything else was way over market. And those prices don't reflect the 15% seller fee...
Sorry, guess I misunderstood. Did you try adjusting the balance? More time in electrode negative (higher number on the dial) will give greater...
Are you trying to use a green tungsten with balled end? That doesn't work very well on an inverter. Try red tungsten with a point.
Certification is not a general title, but for a test for a specific process, application, position, etc. Some certs will cover a variety of...
Not sure about '41 Merc but the '40 Ford Deluxe convertible went for $25k.
The other Deuce tudor with lots of rust sold for $8k.
Separate names with a comma.