The Jalopy Journal
Those oil lines look great, just getting started on mine, been gathering stuff for a few years now[ATTACH][ATTACH]
I am pretty sure the wheels were on this ride, I think I have a better picture, if it can be found?[ATTACH] [ATTACH]
I was able to score these wheels last week, wondering what they might be[ATTACH] [ATTACH][ATTACH]
I am trying to get a dash ready, too many choices[ATTACH] [ATTACH] [ATTACH]
This sounds like what i need to do, Did Don Ferguson do the work for you? I spoke to him on the phone, not long after I bought the heads, but I...
I am getting ready to build an engine for a NOS set of Ardun heads. The heads have the stock seats, as seen in the pictures, and I have concerns...
[ATTACH] [ATTACH] [ATTACH] I went to put some gears into my quickchange this weekend, and I seem to have a problem. the lower shaft has a sholder...
2 jumper wires from the condensers to the dual coil plate did the trick, I now have spark at the plug, thanks
The Coils that are on it now are 6 volt, I do not know if they are any good or not? I do not have the engine or Distributor grounded, other than...
my question is where does the negative terminal of the coil go? should the negative side of the coil be grounded to the engine or frame? The...
[ATTACH] [ATTACH]
Separate names with a comma.