The Jalopy Journal
Cody cleaning under a 65 Elco.
This is what my 28 weights with a half tank of fuel. It's pretty much neutral without me in it....
When your hat blows off, you've chopped a little too much.
My bad I was looking at the drawing instead of the picture. The cuts are off set in the drawing but center on the actual metal. Start welding!
I wouldn't think twice about using those plates. I would put the cuts opposite of each other (outer to the front, inter to the rear) and weld it...
[ATTACH] Like this? Send me a PM.
I didn't have a custom axle made. I pulled another short side axle and cut the rear end to fit it. If I break one I can find another one anywhere.
Used it last night! It works great. I use his clears also.
351 Cleveland 4V open chamber heads for sale with comp cams springs. Heads redone about 450 miles ago. $500 or trade for?
Also have some high...
Chip board I think?
[ATTACH] 4" drop axle in front coilover in rear.
Separate names with a comma.