The Jalopy Journal
Chris, At one time I had an "Indianapolis" Morton & Brett head like that with the 3 intake ports. These were early Model A heads and Morton &...
This ad is from 1941, Please note the name is George Wight not Wright[ATTACH]
Right now you can buy a brand new Riley 4 Port out of the original patterns and bolt it on. How could you even think of a small block chevy head.
Retson, pretty sure the cap you show is a GM with the quarter turn clips and you would lift the door to adjust the points with an allen wrench.
Meyer carburetor. Haven't seen another.[ATTACH]
Reason, I have that engine. It was used in the Merrymen car club (Long Beach) dragster. When I got it the Cragar head was not salvageable, it also...
[ATTACH]
The water manifold was made for overhead cams, with this you are pumping water into all the original block ports. Takes a bit of drilling,...
Reason, here is a multi clutch from an early 30's sprint car. The flywheel has been cut down to 8 inches and a seamless steel tube has been...
29Sleeper, I just looked and he does show the pan on his site, but looks like he reworked the patterns so you can now run an oil pump in the pan....
[ATTACH] Kevin, I had a rough casting like yours and sold it to the late Bob Lee 35 years ago. I bought it from a fellow who had a lot of Gemsa...
[ATTACH] Hey Kevin, You can borrow mine.
Big Winfield barrel throttle tuned with a sleeve, The second Winfield's throttle is running in ball bearings. These are both Model N Winfield's...
Thank you Dan and John. It's a T crank made to Model A specs, being a casting I always felt uneasy about it. I have a Scat crank and a reworked...
Separate names with a comma.