The Jalopy Journal
I found this old post...hope someone will see it....MY QUESTION...I have a NOS switch for a 400 tranny ( I guess)....can I use it on the 350...
Sorry I went to bed early.....This engine was apart when I got it...so I'm not sure about the points set-up....However I did purchased a new...
Where can I get one...the one I have the wire is broken..
Thanks so I can leave it out...right.. Thanks so I can leave it out!!
I have a 71 350 and I have a coil with a condenser of some sort attached to the left side of the coil...I'm wondering what this is..is it a...
I gave up..the motor is in...I just finished it today......I will pray my son..
I'm a man of the cloth....
Been away for a bit..anyways I'm ready to install it...leaving the nut inside no luck removing it.....sometimes I wonder......"did it really drop...
yes I did take out the freeze plug on that side...no luck....might try it again tomorrow and shake the engine a little more and see if it will...
Might try this tomorrow...like you mention..it went it it might come out!!!
So you think that the water ports are large enough to get the nut out...??
The nut fell into the cooling system port...not the cylinder intake..see pics at top of post...
The air thing sounds easy..will try that tomorrow..a friend told me to try a shop vac and suck the thing out.. I think that since the nut fell...
Some basic info diagram.....on the water [ATTACH] flow...I'm going to let it go..leaving it in the cooling system..
Separate names with a comma.