Media for user: Tony Martino
Check out all media uploaded by Tony Martino
@worthop Hello @worthop, it worked a bit better (10%?)than the two Rochester BC's I'd rebuilt and a Carter 1bbl too. A little more seat of the pants, but not much, it could be my fault. I didn't...
looks f............g awesome
@JeffB2 I ran across your reply on another site and had to come here and make an account so i could see your build. i made a post on the forum about doing this swap on my 55. with the exception...
I was wondering if when you removed the distributer you checked the front of the cam for a grind? I have the identical flathead, 59 AB, also .040" over. My cam is stamped "Weber F2". Pretty...
Frame was built by Steadfast with a flat cross member - mono spring - 4inch dropped axle.
- Uploaded Media:
- Embedded Media:
- Disk Usage:
- 94.4 GB