Notching the frame. Got to make plates tomorrow.

You gonna ebay that original Henry steel?

Dang bro, go for it.

Gonna make a set of ice skates out of them!

...lookin good man!

Make sure you make it big enough!

I plan to move the axle back at the drags to hold down the wheelie problem. Then on the Road Atlanta course, I'll pull the axle forward for Akerman alignment.

Dang cuz, you got 'er deep!!! If it wuz me, I would put some plate on the inside of the frame (maybe from crossmember to 'bout 2" past the notched area). Just doubling it up for insurance, but that's just me. You wouldn't see anything just doin' the inside. Like I've said before, I tend to over-do some shit sometimes....
Gotta love progress......hammer down!!!!!!

Thanks Tim! I plan to make some plates. I got 1" above the frame rail before it hits the floor pan. I'm with you over doing is the way to go.

hmmm can i smell HAMB drags 2011?