HOLES THREAD...drilled axles,backing plates,anything.lets see'em

Here's some of the holes in my chevy vicky.

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

Very cool II FUNNY!
I haven't seen fenders drilled in a long time,
and the Chevy axle is tits!

 

Did this a couple of months ago, guess I forgot to post a picture:

 

Just wondering if the drilled backing plates mean no brakes in the wet ??

 

Custom front end under my daughter's stroller.

 

bombshell betty's butt

www.rocketheadsracing.com

 

Not HAMB correct but it got holes.......

& more holes

http://www.jalopyjournal.com/forum/album.php?albumid=30451
T

 

Here's the front stub on an altered wheelbase chevy II I had.

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

And the interior.

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

Doors too.

"MELTDOWN DRAGS"
July 20, 21 2013 at Byron Dragway Byron Ill.
www.meltdowndrags.com

 

Here is the anti-roll bar for the 34 Ford Sedan that was added a couple months ago.

Before Chrome



After Chrome

 

That does it, going to drill the backing plates on my 8 inch while it is torn down.

 

Mutley, Youve got more room on that comet deck lid, get the drill back out.

 

front crossmember. i'll drill the rear as soon as i determine where my tank mounts are going. i'm considering drilling the hurst mount also

 

That should be in a F**king Museum!!!!!!!!

 

Yeah, I know but at that point I had had just about enough of the drill and hole saws.

 

My meager contribution; 2 1/4" holes in the visor, 7/8" holes in the front axle, and 3/8" holes in the 9" rearend backing plates.

 

see what you made me do....

 

Hadn't planned on any holes for this new car, but some pieces just cry out for it....



Torque arm for the quick change.

Bear

 

Here's some void space in my 32 sedan.

 

Here's a few I did on my 40 PU..........cw.

 

A few more on the chassis & tach holder........

 

The inspection plates on the doors.......

 

You guys are all going to whistle when you get over 40 mph.

 

good thread!