Hot Rods 40 Plymouth rod build

Just got body back from being blasted and primed and after Googling what body filler to use, there's alot out there, just got back into this after about 25 years. Straight axle on front , so hoping chunks aren't falling off bouncing down road.Just looking for input of what really works. Heard Evercoat 156 is good? Blending in rear fenders,covering up seams,and should I go down to metal before applying filler or is roughing up primer adequate, been told both ways.

 

Are you spot welding the seams? If not cracks will appear over time.

 

I use Evercoat Rage Ultra and always go to bare metal.....

 

Yes they are, thanks

 

thanks, your like the third person that mentioned Rage, probley order it

 

UPOL, just bought some more this morning to skim my truck frame. I like their Dolphin glaze too. Made with real Dolphins, mmm dolphins.

 

I like Evercoat Rage Extreme over epoxy, Also as a glaze USC Icing is good. I would use some All metal filler on bare metal in seams and weld joints.