Features *Lets see those detailed traditional engines!!

Here's the engine in my coupe.

Sent from my E6782 using The H.A.M.B. mobile app

 

Very Nice!!

 

http://www.jalopyjournal.com/mobile-gallery/
Mine:

41d795048b297266a30e4c093ca3cd86.jpg
My dads:


Sent from my iPhone using The H.A.M.B. mobile app

 

Mine:


Sent from my iPhone using The H.A.M.B. mobile app

 

Another of my Pops!
Does he put him anything! no!




Sent from my iPhone using The H.A.M.B. mobile app

 

Love'n that "Y" ,26 T Ford RPU..
Over the years from 1959 up,I've had three types of carbs on my 1957 Y,the first was 2x4s using a pair of carbs off a 57 Cady,but sold those{got a new wife in 65 an needed $}.Then just a 4bl,but missed the 2x4,so built 4x2 homemade intake from old driveshaft.

 

A hated SBC we recently fished up for a build.

 

Is that exhaust manifold a factory unit? Aftermarket?

 

Built buy United Engine Specialities .

 

Hey Shift Wizard,
I think the guy you are looking for goes by Richies-nostalgic-auto-parts on feebay.

I may be wrong but that looks like his work.

I had seen those angled finned covers on there and when I walked past his booth at the Portland swap meet they were unmistakable. I talked with him for a while, he was a good guy and makes some cool stuff.

 

These are after market reproduction Fentons.

 

Here is my 59AB in my 37 Slant back.



Sent from my SM-N910V using The H.A.M.B. mobile app

 

My 32.

 

My roadster

 

...robber...i have to say, that is super clean, and wicked display of cubic inches! Very impressive, accurate bending on the fuel lines!


Sent from my iPhone using The H.A.M.B. mobile app

 

...MOTOV8N... you sir have a keen eye for the details! Gallons of thanks for the comments!

 

That looks great! What intake is that? What distributor are you running?

Your alternator bracket looks pretty neat, too.

 

Edelbrock PERFORMER EPS, MALLORY UNILITE DISTRIBUTOR. Thanks for the kind words. P.S. That is an orig. Caddy. filter not a re-pop.

 

It's fairly similar to what I'm planning for my 283 I'll be putting in a 28 RPU. My heads are early and don't have accessory holes, but I'll be mounting my alternator low instead.

I'm planning on using a 4bbl and wasn't sure if it would look just right, but seeing yours definitely convinced me!

That Caddy air cleaner looks terrific!

 

Now Pops is putting a 5speed on his flathead to sit on an engine stand!
Lol!


Sent from my iPhone using The H.A.M.B. mobile app

 

Here's my Old Man's 53 8CM Merc. Not finished yet but pretty close.

 

From my old 32.