Hot Rods Iron duke in a model A

This appears to be the non marine intake needed for the 181 head,,,,forklift etc.,,not sure if I'd find one in my area but I will try,,,a bit pricey new though,,,

 

Any chance there is an exhaust manifold that goes with it? I would sure appreciate a link when you post.

Charlie Stephens

 

Wish I wouldn't have sold my Iron Duke!

 

There is a compatable exhaust manifold ,I have a pic on my P.C. At home will post it later ,the pic is blurry but the style is ok ,outlet appears smallish in pic ,

 

There ya go Charlie ,,what do you think about the outlet neck size,,,

 

WOW. It almost looks like a photo distortion. I wonder if the forklift exhaust systems were all one inch? Thanks for posting it.

Charlie Stephens

 

Given the cost of manifolds, it is probably best to buy a used Hyster engine

 

The illustration looks like the 153 inch version. Did they also have a 181 version and what is the site address?

Charlie Stephens

 

http://www.allpowerlabs.com/wp-content/uploads/2015/05/GM_PSI-3.0L-Engine-Service-Manual.pdf

 

I am confused, the original question was about an Iron Duke swap and yet most of the responses concern the Chevy 153 engine. They are NOT the same animal. While having very similar displacement, the true 151 ci Iron Duke was produced by Pontiac from '77 to '93. It was also used by Chevrolet and AMC.

 

this -Sorta- looks like the 21st century exhaust manifold found on the Toyota lift trucks that used the 181