Register now to get rid of these ads!

????Freeze plug size 460 Ford

Discussion in 'The Hokey Ass Message Board' started by old beet, Nov 5, 2008.

  1. old beet
    Joined: Sep 25, 2002
    Posts: 5,752

    old beet
    Member

    Need freeze plug size for a 73 460 Ford, the one under the driver side motor mount. Will save me a long trip! Thank you.....Beet
     
  2. old beet
    Joined: Sep 25, 2002
    Posts: 5,752

    old beet
    Member

  3. yorgatron
    Joined: Jan 25, 2002
    Posts: 4,229

    yorgatron
    Member

  4. old beet
    Joined: Sep 25, 2002
    Posts: 5,752

    old beet
    Member

    Thank you!!!!!!!!!!
     
    Register now to get rid of these ads!

  5. 39 Ford
    Joined: Jan 22, 2006
    Posts: 1,543

    39 Ford
    Member

    Autozone can look it up on thier computer, use the rubber bolt in kind it's lots easier than pounding in a steel replacement, where you have limited swing area. Save the steel ones for engines that are out of the car.
     
  6. I like the rubber expandables too, easier to install if the access is obstructed. I used to use the marine ones on the rear of the blocks, those never rot out.

    Bob
     
  7. BobbyFullen
    Joined: Sep 22, 2008
    Posts: 100

    BobbyFullen
    Member
    from Kerrville

    1 1/2 is correct.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2013 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.