Register now to get rid of these ads!
  1. NEW JALOPY JOURNAL & H.A.M.B. MERCH!
    Hey fellas, we've just re-stocked the store with a couple of great new t-shirts, an incredible jersey, and just about the best damned ball cap ever made. Put it all in your wardrobe and you'll be the sharpest dressed man in the pits - that's a promise!

    Anyway, to check it all out just CLICK HERE!

    (To get rid of this notification, just click the little grey 'x' located in the top right hand corner of this notification box.)

Ball joints 60's Comet

Discussion in 'The Hokey Ass Message Board' started by projim64, Sep 11, 2009.

  1. projim64
    Joined: Sep 10, 2007
    Posts: 164

    projim64
    Member

    Looking for info on ball joint specs for a 64 or 65 Comet.
    I am looking to find out what size they are (taper,length etc. ) .
    I would like to build some Chrome moly tube lowers and uppers and am looking for info to compare to some of the screw in type to find some ball joint sleeves and ball joints that will work.
    Any info would be appreciated they are for a N/SS replica car of Dyno Dons 65 Comet Cyclone.
    http://422allstars.com/9-6-09/9-6-09 026.jpg
     
  2. falconwagon62
    Joined: Mar 17, 2006
    Posts: 1,386

    falconwagon62
    ALLIANCE MEMBER

    Same as a 66 mustang.. That should make it easier to find.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2013 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.