Register now to get rid of these ads!

Hot Rods '32 Ford pictures

Discussion in 'The Hokey Ass Message Board' started by D Reed, Jan 29, 2010.

  1. D Reed
    Joined: Feb 24, 2008
    Posts: 423

    D Reed
    ALLIANCE MEMBER

    Does anyone have any pictures of a stock '32 Ford 3 window seat showing the curved side wood supports?
     
  2. Deuce Roadster
    Joined: Sep 8, 2002
    Posts: 9,520

    Deuce Roadster
    Member Emeritus

    :)

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    The above photos are of my 32 3W. The ones below are of someone else's 3W.

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
  3. Deuce Roadster
    Joined: Sep 8, 2002
    Posts: 9,520

    Deuce Roadster
    Member Emeritus

    Here are the specs for the bottom seat pan.

    [​IMG]

    the following measurements from an original 32 3-window seat pan: front overall width = 37"; rear overall width = 39 7/8"; front to back overall length = about 22"; side-to-side distance between bolt holes for the two pan-mounted seat tracks = 31". .


    When the back board on mine was redone ... cabinet grade birch plywood was used. The entire back panel was made to be the same size but just one board, not a series of 7 pieces made into one back rest. I believe my version is stronger and was easier to duplicate.

    [​IMG]
     
  4. D Reed
    Joined: Feb 24, 2008
    Posts: 423

    D Reed
    ALLIANCE MEMBER

    Thanks for the reply and great pictures. Did you happen to save the patterns?
     
    Register now to get rid of these ads!

  5. Deuce Roadster
    Joined: Sep 8, 2002
    Posts: 9,520

    Deuce Roadster
    Member Emeritus

    I actually made the patterns OFF mine for a HAMBer ... I mailed them to him at least ... 2 or 3 years ago :rolleyes:

    My interior is finished now ...

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    ... I could TRY and another trace a set ... for you if that would help. :D

    [​IMG]

    [​IMG]

    [​IMG]
     
  6. D Reed
    Joined: Feb 24, 2008
    Posts: 423

    D Reed
    ALLIANCE MEMBER

    Thanks for the offer but I'll take care of making a pattern. Very nice job on that beautiful coupe.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2013 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.