Finally picked up a dual carb setup for my '52 331 Chrysler. Its a cast iron manifold for two stock Hemi carbs. Any idea if this was some factory made piece or produced by a speed equipment manufacturer? Thanks, -Dean
If it's not for a 51-53 it will need to be modified for it, unless you have later heads on the engine.
Its definetly for an early mill, but its not dual quads. It takes whatever a stock Hemi took (1 or 2bbls?) I'll try to get a pic... Thanks, Dean
Yeah, that's the idustrial intake. They pop up on ebay from time to time. The original air cleaners are badass little oil bath looking deals that would be awesome chromed out. I tried to get one a couple of times until I found my 2x2 Edmunds!