tru spoke wheel lug nut fitment

how deep does the lug need to be? i have some but they bottom out even with the thick washer.is there a spacific lug nut for tru spokes? thanks billy

 

With the washer on it should be a little shy of being flush with the the back mounting pad (spacer) hope this helps!

 

i think the lug nut is to long if i double the washer it will get tight but i dont know if it will tork down properly. what should the tru spoke tork to? these are old ones 15x7.

 

do they have the spacers on the backside? they bolt on with 4 screws

 

No the only thing i have is the wheel adaptors i had to go 5x5 to 5 4 3/4 and they are 1-1/4 thick the good ones.the tru spoke would not clear my hub center on the rotor.

 

Are you sure you've got the right washers?? Maybe the P.O. (if there was one...) gave you some that aren't the right thickness?

 

They make short and long shank mag lugnuts. Are you already using the short ones?

 

check with lug nut king. i believe he's in san diego ca. i needed 1" long shank ones, but im running the factory spacers that come with tru's.

 

Do you have pics of the spacers? I did not know they had spacers. Maybe thats my problem.

 

The lugs are 1" shank i belive.