The Jalopy Journal
Where can I find info on the NH airfield show?
guess I'll have to figure it out on my own
I got the same type of material as the lowes stuff but in a 3 ft wide roll. you can get it for what works out to 1$ a sq ft on that auction site...
Hello I just got all of my stainless polished and need to install it. Problem is all of the holes have been filled(welded). What will be the best...
this my first attempt. still need to install the side trim and fix the front altitude.
welcome aboard. before the forum police come down on you, post an intro in the new members section. Secondly this is not the place to speak of...
check home depot, i've bought numerous fittings there and adapters
If you get a box out of the " extreme" package offered in later s-10's it has a quicker ratio steering box. I think the official name of the...
Any other opinions on the show? is there a swap meet area?
thanks, guess I'll tackle my re wirering job out in the garage instead
I'm thinking of checking the show out tomorrow but not sure if I want to drive an hour and a half to do it. My biggest concers is that it will be...
next the damn thing will be doing our surgeries too. pretty amazing use of technology though
scuff it up well, make sure and remove any rust. really just prep like you would any other part of the car. rustoleum woeks fine for what you are...
Can you find a set of poly-urethane bushings already made?
Are you only looking to polish the raised area on them or strip the black?
I have a 01 v6 dakota quad cab and had to haul both over hilly terrain and on interstates with a 47 ford tudor sedan. sometimes it was a little...
yep spray bomb. spend a few bucks for the better thicker stuff not the buck a can crap at walmart. that's how I did mine in my avatar
well, you have it might as well run it while you save for a good one
also have the boots good and warm. I usually set mine on the hood on a summer day until I use them well lubed. I prefer a little silicon spray or...
I went like 250 miles or so one way with a uhaul trailer. I'd do it again. I think I paid like 40$ picked it up saturday morning brought it back...
thank you but I wasn't looking for opinions on my set up, just how to make it work. the 2004r was a no brainer as I was replacing a th350. I've...
I know on a sbc in an s10, the drivers side runner loops around your steering shaft and the engine is usually offset slightly to the passenger...
I currently have a sbc with a single edelbrock 600 in front of a 200-4r. I would like to put on a tri-power but am totally lost as to making the...
I've never had any problems with my bias ply tires. Have to admit with growing up on radials(I'm 37) that there was a slight learning curve when I...
Yeah I"m in the same boat cept I have a 200-4r with somewhere around that 2.80:1 rear. although better than it used to be when I had the th350....
Well you are better off giving him a package then receiving his. oh never mind he's dead anyways
How's the saying go? Good, Fast and Cheap...pick any 2" I find this to be one of the truest statements ever.
How are you controling the lock up on the stock converter? if it isn't locking up during cruising, wouldn't the slippage generate extra heat?...
thanks for the link. Slowly I'm gaining reasons to go on facebook. I had tuned out of it due to so many whineasses.
Separate names with a comma.