The Jalopy Journal
Any of you guys rebuild a Muncie trans by yourself? I have an M22 and M21 that I want to rebuild . This would be my first time. Both trans have...
I have a BBC with LS6 iron heads and Hooker Super Comp 2.125" headers. Not getting a good seal with the current copper round port header gaskets....
I look at them often. They are in containers now, inside. I would like to find some magazine binders similar to the old Hot Rod magazine red...
Finally got this one, Issue 1, Volume 1. Expensive but completes my collection of SSDI, 1964-1975 (the years I am interested in)...
very cool car. Does your crank have a double crank keyway for the blower? What static compression ratio are you running?
I'm in the Raleigh NC area. Need a good body and paint guy to work on two front fenders (already removed from car). They are in good condition, no...
I have a '66 Biscayne ( same chassis as a '65), 496, 4 speed, 12 bolt, M/T 10.5/29/15 slicks. I am trying to improve traction when I launch this...
Anyone here running a rear block protector plate with a gear reduction style starter? I just mounted a new gear reduction starter. on my big...
not mine, but someone is going to want this......
Need to have my newly rebuilt M22 looked at. Just installed, new Hurst shifter setup, won't go into 4th or find neutral. Seemed okay before I put...
Hello fellas, I need to find a local shop that can make a shaft for my '66 Biscayne. Going to use 1350 U joints. I see the guys on ebay but I have...
thats PERFECT!
Setting up the clutch linkage on my chevy. When the throwout bearing is correctly seated on the fork it should be able to pivot, correct? But when...
My Biscayne will have a healthy 496 BBC installed shortly. It is currently running a smallblock with a Muncie and 12 bolt rear. I has 1330 series...
bump. Good trans deal...
Muncie M20 4 speed, new rebuild using Supercase main case, new bearing retainer, new full kit including syncros, bearings, seals, etc.. Big 1 inch...
Okay, Im in. I need help too. I have a mid 60s Biscayne that is being upgraded from smallblock/Saginaw 3 speed to 496BBC/M22 this winter. I have...
next time try fabbing the wheelwells using cardboard to form patterns. Then transfer the patterns to the sheetmetal. Saves time and sheet metal...
It was a double pumper #4777-4
the hard start may be due to the fuel being dumped in your manifold after you shut it off. Fix the carb and maybe the starting issue will clear...
VICTORY IS OURS! pulled the Holley and bench tested it. Removed the float bowl sight screw from the rear float bowl, tipped it over and fuel...
So, I hooked up my remote starter and cranked the engine over a few times. Then pulled the boots and plugs on the cold tubes, 3, 4 and 8 to check...
How do you ground a plug to the engine to confirm spark?
Started up my 327/Holley 650DP after a few months of sitting. It was running fine when I parked it. Now it runs like crap, won't idle, popping and...
ditto...
I plan on running one behind a BBC, so I would like to know too...
Fellas, I have a '66 2dr. 327/4 speed Biscayne. Same body style as the '65. Am I in trouble if I post pics or ask questions about? Or does it fall...
Wow! fun link. Where are my cut-offs?....
Old Polaroids Paste and enter:http://www.flickr.com/photos/bykyak/sets/72157623160463384/show/with/4255048914/
Separate names with a comma.
The Jalopy Journal
