The Jalopy Journal
Still for sale Sent from my iPhone using The H.A.M.B. mobile app
Gimpy, your first two pictures don't show up, but the bosses on the front of the block are there, but not drilled Sent from my iPhone using The...
Squirrel, as always, thanks for your help. Sent from my iPhone using The H.A.M.B. mobile app
Yeah, I didn't know either. That bracket may work. Thanks Sent from my iPhone using The H.A.M.B. mobile app
Well, on the 283 the upper hole definitely went into the water jacket, but if they are both blind holes(or supposed to be) drilling may just be...
I know one hole goes into the water jacket, which isn't too big of a deal. I won't be in the shop until tomorrow. Is the lower hole blind or what...
I'm replacing a 283 with a 400. The car takes a short water pump and the 400 block does not have the threaded holes on the front of the block near...
The body is a N and N out of Arkansas. The pedals say raise and lower. They came off of some type of old medical equipment, but the verbiage...
[ATTACH] [ATTACH] This is my first experience with building a 'glass car. The body is very well built and is a hell of a lot more fun than not...
I know this isn't what you asked, but I agree on the alternators looking very wrong on a flat motor. On my old hot rod I didn't want to pay up for...
Bump Sent from my iPhone using The H.A.M.B. mobile app
bump
The c6 takes a lot of power to run. Some sources claim about 50 hp. They are also pretty big, but under a truck shouldn't be a problem. Have you...
Btt Sent from my iPhone using The H.A.M.B. mobile app
1931 Ford Model A 4 door sedan hot rod. Fun little sedan with a stock height Briggs body. All steel except for hood and grill shell Fully boxed...
Are you sure the linkage is adjusted properly? Interesting description, snatching. I've got a fresh AOD that does something along those lines....
I'm guessing you need a "ford big cap" u joint. Gimpy put up the picture with the paper clip for reference I was going to go find.
Back when I had my '40 Ford Tudor someone asked me if it was a really old PT Cruiser. I just said yes and drove away. Sent from my iPhone...
I just swapped a 'glide for a th350 in a '57 Chevy. It fit fine in that. If you get a short (6") tailshaft, it is close enough you may or may not...
I don't have a picture of it at work, but I almost always drive my hot rod to work. Everywhere I go is at least a little better if I got there in...
I'm pretty sure Mac's sells them, or used too. They are sort of expensive and the last rear end I had that needed them, I converted it to Explorer...
Mine, I sold about 7 or 8 years back. [IMG][IMG]
I could stare at that for a while....but I'd rather drive it. Nice job.
I don't have an answer for you, but I'll bump you to the top 'cause I want to see a picture of your set up. It sounds neat.
easy to apply, easy to repair, not what I would use on a show car, but works great on everything else. Also, I don't understand why so many people...
Some pics for you. It's hard to say what all has changed on these cars over the years. The more I dive into this 57 the more my head spins at the...
I'll take a couple pictures for you tomorrow. This car has a fair at best reupholstery job. And your welcome in advance.
Separate names with a comma.