The Jalopy Journal
Thanks for the Information, It was just what I was looking for. Jerry
I have a SBC 283 with dual quads(Edelbrock 1406's). I know that normally with one Edelbrock the car likes no more than 4.5 lbs fuel pressure....
Thanks for all the help and info. I found a set of plans on EBay that will do me just fine. Thanks again - Jerry
Willys replacement parts is the ones that want $425.00 a pair.
I need a pair of door hinges for a fiberglas 41 Willys coupe. I have checked around and no way will I pay $400 for a pair. I have tried to make...
Thanks for the info - I found what I needed.
I am about to install the upholstery in my 28 Model A coupe and ran across a ptoblem. To install the windlace on the doors is no problem on the...
Anyone familiar with the procedure for installing a new windshield in a 28 Ford coupe? Other than take it to a professional to do it. Thanks -...
I am prepping my 28 Model A coupe for paint in the spring, my question is whether to paint the frame and front end(no hood or side panels) with...
Same
Go to your Home improvement center and go to the screen door section. There you will find aluminum mesh that you can cut down and put on the...
Thanks for the info. Jerry
Anyone know where I can get a Buick straight camshaft reground or a new one? Thanks - Jerry
I don't know what dash it is but it isn't a Model A dash.
Thanks for the info. From what my buddies are saying and what you guys just said I am going to be happy with what I have. Thanks again
I have a 28 Model A coupe and don't like the look of the doors overlapping the body. Does anyone have any experience in modifying the doors and...
The planning was fine but I shifted gears in the middle and went from a stock Model A size radiator to a cutdown radiator. I might just try the...
The firewall and block are where I want them. I was thinking of a new firewall and setting the motor back a couple of more inches but I would...
I have a 28 Ford Coupe w/SBC and need to make the hood longer, does anyone have experience in this area and can guide me along? Thanks - Jerry...
Thanks for all the information it really helped. I reshot all the bad areas and it came out perfect. Jerry
Pimpin paint - The thinner was reduced 125% as per their instructions. Do you think I should thin it out further? Thanks - Jerry
Thanks for the fast answers, due to the current weather it sounds like you have a handle on my problem. Thanks - Jerry P.S. I just checked the...
I went to spray on Black lacquer paint with a Sharpe 998 Siphon feed HVLP gun(I know buy a regular HVLP) and at first it sprayed on nice and the...
Thanks for the fast answer the link is just what I was looking for. Thanks again - Jerry
Anyone know a site I can go to and find out the gear ratio in the Chevy T-10 I have? All I know is that it is a close ratio box. Thanks - Jerry
Frank - Thanks for the info - What year/motor Ford/Chrysler have 11/32" valve stem seals knowing that the counter guys only go by Year and make,...
Thanks - The PCV is not stuck and I knew that I could do the work with the heads on the motor, I am trying to locate the problem Guide or Seal. I...
I know this sounds like a dumb question but I have a SBC (283) that has started smoking(blue smoke) after I cranked it up after it's winter...
Guys - Thanks for the info
I have a T-10 close ratio box in a Model A w/SBC(283) and 2.73 gears in the rear end. How much trouble is it convert the box to wide ratio so the...
Separate names with a comma.