The Jalopy Journal
I have a 4-11 ring gear and pinion for a 9" ford rear end. It was purchased from speedway. I also have the 9" overhaul kit to install it prt...
Thanks for the help. Will look for some 70 Dodge springs. Thanks again
I'm building a 36 ford slant back and need some help with the rear leaf springs. I have a 9 inch rear end and have gotten the rear end mounting...
Thanks for all the good information it is very helpful
I have just purchased a 33 5 window dodge coupe and was wondering if anyone knows the difference between the 33 and 34. There seems to be more...
I have a electrical gauge on the passenger side and a mechanical on the driver side. I think I am going to replace the electrical with a...
3 years age I bought a can of Por-15 and couldn't get the lid off. Found a good sized lag bolt punched a hole in the lid and used the lag to seal...
Thanks for the help you Hamb guys always come through
I have a ford flathead with dual 97 carberators. I have the little chrome air cleaners and they don't seem to pass enough air. Does anyone make a...
I just received 2 u shaped springs that close the glovebox door on my 40 ford pickup and am at a loss as to how install them. Can anyone help me...
Thanks to all again. I've had this kit since last Christmas thought it would do the trick, but as i'm sure you all know when building a car...
First thanks for all the helpful advice. I have ordered 85# solenoids from auto lock and I am going to use the spal sender with the built in...
I just installed a Spal shaved door handle kit in my 40 ford pickup. The solenoid doesn't have quite enough power to pull the latch. I was...
I'm getting ready to have the glass cut and installed in my 40 ford pickup. I would like to do away with the center bar. Does anyone know where I...
Thanks all for the great info. My concern was clearance. I will get the 90 degree elbows and that should solve the clearance issue. Right now I'm...
The new master cylinder should be here today. will get it installed and take some pictures. Will probably have to get help posting them.
I'm replacing the master cylinder in my 40 ford pickup with a mustang dual cylinder. Its is under the floor. I was wondering if anyone had...
Thanks for all the input. I should have done my homework better on brakes. Does anyone need a new single master cylinder? Thanks again
The shop that has the adapter does specialize in brakes I will call them first and get their advise. That is a very good suggestion. I have a 9"...
They pretty much stay locked up or very tight.
Thanks that is my thought. I started this project 4 years ago and didn't do much research on brakes. I'm building a 40 ford pickup and have had a...
I have looked through and read any thread I could find on front disc brakes locking up and my only question is has anyone ever been successful...
Thanks for your reply. I now feel better and will give them a call. thanks again
I have been working on a 40 ford pickup for 3 years now and you guys have helped every step of the way. I have looked high and low for a hood...
I'm finally going the HAMB. Should have done it years ago. I have gotten a lot of great information over the past 4 years for you guys. I am...
I am about ready to install windshield wipers in my 40 pickup. I was wondering if anyone has went to the salvage yard and found anything that will...
I'm getting ready to start my rebuilt 50 flathead. I've read and read on here the advantages of a filter or not. Everyone her says I should use...
Would you be interested in selling them? my e-mail address is [email protected] Thanks for your reply Jim
Does anyone have the measurements of the oak box mounts on a 40 ford pickup? I would like to make my own, appreciate any help
I want to install the modern tube style
Separate names with a comma.