The Jalopy Journal
Knoxville dragway
You got it right when you said "true Car Guys" there are still a few left.
Try buying a few cobalt drill bits, that is all we use in the shop. They hold a good sharp edge for a long time. Cutting oil also helps. Motor oil...
Is this a flux core wire welder and you are trying to use regular mig wire with no gas?
Anything at all except Rebel!.
You read it wrong, go back and read the whole paragraph. :D
If you are wanting to build a rat rod then go with steel, if you want a nice painted T then glass is the way to go. Rust, I don't think you can...
You can buy J bends and U bends from a lot of different places. They go along way, to building a set. Speedway, Jegs, Summit just to name a few....
You can do that with a Vega box, mounted under the frame. we do it all the time on Ts and Model A. We even keep the brackets to do it with....
EZ Wire for sure. We used to be a Rebel dealer, but we won't go there!
I'd be for checking the timing and making sure the vacuum advance is working like it should.
Good luck with the Post Office. Too much red tape with them. From past experience, you will probably never get your money. We never did. We only...
We have the standard T Bucket body for just $399.00 and turtle decks for just $299.00 and the lid opens on the turtle deck....
1" is all we use on our radius rods. We use a .219" wall DOM. Seen way too many .156" rods fail, always on the rear end. Here is a pic of a set we...
I graduated high school in 1968 and went to work in a NAPA machine shop. The labor rate was $6.00 per hour. Prices for engine work were really...
Had a Cadillac 500 and a turbo 400 shipped by Uship.com from Chicago to Kodak Tn for $150.00. Did not need a pallet or anything like that. Just a...
Where are you planning to locate. Shipping may be an issue.
I got tickets to go see it tomorrow in Commerce Ga.
The weather ain't looking good at all. The weather man says 2" of rain there tonight and tomorrow. Think I'll stay home.
This happened last week in the next county. http://www.wate.com/story/23354771/locals-upset-about-moonshine-bust-in-cocke-county
You might want to try www.hotrodrefuge.com a very friendly hot rod site. They don't care about traditional.
Mineral spirits works great.
We always used 10 degrees.
Seems like a great price to me. That is international shipping! I just today sent a set of Hemi motor mounts to Canada and my cost to ship them...
Yep, try putting some Diesel Exhaust Fluid in the DEF tank. Under the hood with a blue handle, next the trans dip stick.
http://www.egge.com/site/?d=48&dt=1&SubCategoryId=2&make=CHEVROLET&rpp=10 Looks like $346.00 Part # EP2148-8
Do you have the battery terminals on correctly? Pos to pos and neg to neg? I will turn over but it won't fire.
New valves, are they adjusted correctly? They could very well all be off the seats. Run a compression test and then a leak down test. Testing is...
Hypertherm is the Cadillac of plasma cutters. We have 2 in our shop and both do a fantastic job. You will probably need a Powermax 45. It will do...
You have that T truck? bring it.
Separate names with a comma.