The Jalopy Journal
Two Furdo's made. A real 2 speed like the pictures, and the ever popular 3 speed (starts in 2nd and shifts to 3rd in Dr.) Lo range is 1st gear....
Crazy: I was just showing that the OP's math was wrong. And we do make both powered and non-powered converters for vehicles that have LED...
I think your calculations are incorrect. Let's take the 144ohms and see what you get with 12v. 12/144=.0833 or 83ma. 12x.0833=.999 watts. Quite...
Ok, here goes! I am an engineer and work for a Curt competitor. Here is one of your problems, the brake input must have at least one operating...
What kind of voltage reducer are you using? If it is just a resistor, that is the problem. You need to use a solid state reducer, otherwise the...
YOU NEVER KNOW!
Here is a link to a reasonably priced 6 to 12 volt ISOLATED converter....
Looks like 2 holes could be drilled, but the third not so much.
Depending on what your 12v electric choke draws in current @ 12 volts, you may be able to find a DC to DC module that will convert the 6v to 12v....
My take on this thread is that the C4 has a removable bell housing, which is attractive to swapping engines and transmissions. It also allows a...
Back in the 60's I built a little beeper circuit from a Popular Science magazine article. Back then the popular beepers of today were not...
The one I built works pretty good. Turn left and the left Turn signals come on, turn to the right and right turn signals come on, go straight and...
Here's another possibility, depending on what year the 283 crankshaft was for, you may have a TURBOGLIDE crankshaft. I am pretty sure that the...
1893 bulbs are 12-14volts and will be really be dim with 6 volt system. You need #51 or #55 bulbs.
Powerflite was stronger than a Powerglide and had a really stout torque converter with 2.76 to 1 multiplication. Held up pretty well with 300hp...
Here is a Urich's Ben Hur station. Even though this one was in Fresno, CA, the one I remember from the 60's was on Artesia Blvd in Wilmington Ca....
Here is an old Whiting Bros station in Newberry Springs, CA. Remember getting gas ⛽️ there in the 60's while driving on my learners permit. [ATTACH]
Young & Restless (daytime soup)
Grit, determination, and faith go along way! Kudos to you!
What transmission does it have? Cast Iron Power Slide? LOL!
Main character on Y&R.
He either has a stick or a Dynaflow which does have a rear pump. It can be push started.
Just a quick note: Some 1950 Oldsmobiles inhibited 1st gear, thereby starting in 2nd gear. This was done because 1st gear would spin the tires on...
Depends on what the straight 8 to hydramatic has for bell housings. Pontiac V8 to hydramatic used two bell housings. back to back. It all depends...
You may want to cover the transmission cooler on early hemis. Goes between the water pump and lower radiator hose.
I am taking my 57 F100 stock round dial radio and adding a few new components to allow the FM band to be received. As far as the dial, well I will...
I would use relays and have them between battery and headlights. 2 small #18 gauge wires then go to the hi beam switch. You need 2 relays, one for...
Whoever drew up the red/blue marked up diagram has the red going thru the ballast resistor. It goes to the resistor and only passes less than 12...
Are these harnesses old or replacements? If old, then I can believe a short between wiring.
I would cut the head off the bolt, then remove manifold. Soak the remainder of the bolt with penetrating oil. Use a pipe wrench to remove bolt....
Separate names with a comma.