The Jalopy Journal
Depends on your suspension set up. rule of thumb is down 3 degrees on the pinion from the driveshaft. Best thing would be to get it in there and...
gasoline then some water
You need to just set your engine and transmission in there and see what fits best for you. Your blower pulley is going to be a tight fit.
Dont use any of airbagit.com stuff unless you want constant problems. I have replaced lots of components on customers cars that started from other...
Glad i got some early model ends when i decided to weld up my own a front axle
What kind of blower engine are we talking about? I would only use mechanical advance on a low boost stockish set up. I only run locked...
Does not show signs of any water leaking from the deck surfaces but it does show a rusty trail of water entering the valve seats.
rotella 15 40 in everything gas and diesel
cover it in purple power for under $10 then pressure wash it clean.
If you use a fan as a pusher you will never get more air flow than the fan cfm which is not enough to cool most old cars and the the fan is...
You are not going to have a problem that far down in the cylinder, there will be little to no compression on the rings at that point. As stated do...
I in no way related cam lobe problems to the gasoline problem we have now, i was just simply stating in agreeance that gaoline quality is beyond...
You sure he wants you posting these pics?
Burnout2614, yes I agree, dont get me started either on this shit gas we are being sold
You are probably describing a perfectly normal sbc "cast" camshaft, they will have a pitting look in the lobes when they are new and as they...
going from a th350 to glide was the best thing i did in my 27. Why are you changing it?
The holes for the intake bolts look to close to the case. Are you going to cut those big square lugs off the tops off the case?
Someone could learn how a timing light works at the least from this thread, instead its a normal bashing party.
It really sucks some one ask for ideas on something they are inerested in doing and all i have seen is negative comments.
is your drivehshaft bottoming out?
what lift is the cam? I still say coil bind, the late model heads do not have much extra room between the valve guide seal and retainer and that...
That vin is like a college degree.
Dont worry about it! That carb is gonna be leanning alot farther than that when you stand on the throttle and it carrys the wheels 100' in the...
Dont descriminate on the cars past, its not the cars fault the vin got removed, get her, fix love her and drive her.
if you buy a reproduction piece you either will have to rework the stamped piece or smooth it out. I had a customers car and he had us smooth it...
coil bind
$200 is honestly all they are worth. you have a 4-71, big bore 6-71, 6v71 and two 8v71 by the looks of the pic.
That pic on page one looks great to most and its not bad by all means but its not a 100 percent great weld either. With experience you learn how...
my dish soap
i hold a penny on the back side for under 7/16" any bigger use something to fill it
Separate names with a comma.