The Jalopy Journal
[ATTACH] [ATTACH] [ATTACH] [ATTACH] Hello, I bought this a few years back. Traded the truck off before install. Nice condition, carbs look...
This, I think, is a simplex servi cycle. I’ve been storing it for years . Trying to cleanup a little. Someone installed a newer side shaft...
[ATTACH] cleaning out garage. I had a 1966 charger with a 383 at one time. Fan clutch looks new , one bracket is from air conditioning. One...
I have a nice vintage Weiand big block intake. G team. Thought maybe someone could use this. $150 + shipping I could find a part number. Carb...
Hello, do you have premade seat covers or door panels for a 40 ford Tudor? Thanks
still have
selling a 1940 ford coupe steel body project, sitting on a chevelle frame. 454 bigblock 350 turbo. 12 bolt rear. Has roll cage with racing...
Btt
[ATTACH] [ATTACH] Howdy, howdy, Selling this as a package deal. I have two rusty 57 2dr sedan body shells. A rolling frame. With one title...
[ATTACH] [ATTACH] Hello, putting my 1937 Chevrolet 1/2 truck up forsale. It is appears to be original motor with original trans. 4spd....
I have about 10 of each sticker. Ovals measure 8"x5". Petty cars measure about 8"x3 1/2". $6. Each plus shipping. I will ship between two...
I have 8 pieces of the side window door stainless off of a tri chevy 2 door sedan. Bellaire. Take off trim never polished. No major scratches...
Do inner fenders from a 65 chevy truck exchange with a 63? I have a 63.
I'm looking for a owners Manual and some missing parts for an older 4 post challenger lift I have. ANy leads would help. Thanks
Does anyone know the part number for the sbc thermostat housing that has two ports for sensors. I think it might solve my cooling fan troubles
I need some input..... Help..
The sensor came in the Jegs cooling fan kit. It comes on At 185 back off at 175. Water boils at 212. I removed the pan from the burner and did...
Still having a problem. When I ground the wire coming out of the sensor the fan kicks on. I pulled the sensor. I cleaned all of the pipe dope...
I'll try that tomorrow and let everyone know. I might switch ports with the temerature gauge. The sensor wire would be a little shorter then....
Heres what happened. I bought a piggyback fuse and ran the reverse lights to it. I then wired the relay up. I then grounded the sensor wire and...
Here is an Idea, If I switch the wire back from the backup lights to the grey wire that controls the yellow wire to the relay, than piggy back a...
O.K. I had today off for Ohio gun season, Thought I work on the nova wiring instead..... This is what I found out with the cooling fan wiring....
I think its the 12 circuit universal streetrod
One last thought. If I wanted to put a manual toggle on the fan, If the relay would fail and heat up. Would I wire from the red wire to switch...
325w, the yellow and grey wires are on different terminals. I'll have to look at some more tomorrow..... I have at least three months to figure...
Ok Did the test When ignition is on I have power at the fuse coming from the wire marked cooling fan switch(painlesswiringharness) Followed that...
I'll go down and try to ground the sensor wire again. I tried two different relays. I place a male end into the plug for the sensor. If I new...
Here is the actual what I have. [IMG]
[IMG] Heres the instructions. I think iwired it right. OJ mentioned the coil. It has accel HEI. If I flip the two wires around on the ignition...
Separate names with a comma.