The Jalopy Journal
57 T-Bird! Can I get it to run right? (Mart's Garage Update 2417) I got the Thunderbird running, but wasn't happy with some mods I did over 30...
57 T-Bird! Dealing with Door Fit Issues! (Mart's Garage Update 2416) While fitting the tread plates to the T-Bird I realised I was not happy with...
57 T-Bird! Will it run? Will it move? Will I wash it?! (Mart's Garage Update 2415) Having done what I can on the 100E I wanted to rearrange the...
If the pistons are stuck, the crank should move just a little bit back and forth. If the cam is stuck the crank should still move a little bit....
Tidyup starts! Let's move Old Rusty! (Update 2414) Having done what I can on the 100E I wanted to rearrange the cars to give better access to the...
Hi Neal. Great looking dash/gauge/switch/wheel combo.
Last few parts go on! Tinker Time! Mart's 100E part 75! (2413) Hello! Welcome to Mart's Garage. In part 75 of the 100E Anglia resurrection: I...
Loving this build, Neal. The car looks great and the work on the steering boxes is fantastic. Mart.
Tinker Time! Let's sweat the small stuff! Mart's 100E part 74! (2412) Hello! Welcome to Mart's Garage. In part 74 of the 100E Anglia...
Wow! Well done Mr Lamb.
Fragile old rubber mats. Let's reinforce them and get them fitted! Mart's 100E part 73! (2411) Hello! Welcome to Mart's Garage. In part 73 of the...
Lucas voltage regulator adjustment! Mart's 100E part 72! (2410) Hello! Welcome to Mart's Garage. In part 72 of the 100E Anglia resurrection:...
Smiths speedo Repair and calibration! It's in the magnetism! Mart's 100E part 71! (2409) Hello! Welcome to Mart's Garage. In part 71 of the 100E...
Nice looking little two door there, Mike. 2408: 100E video 70: New tank seal plus 2nd attempt at speedo repair. [MEDIA]
2407: 100E Speedo failed repair plus storm Isha damage. [MEDIA]
2406: 100E video no. 68. Putting the windscreen in. It didn't go particularly well.. [MEDIA]
2405: 100E Vid 67. Low volt investigation and fix plus windscreen removal. [MEDIA]
2404: Get your kicks in vid 66. [MEDIA]
2403: Mission Creep 100E part 65! New Old Dip Switch, plus Gifts! [MEDIA]
2402: Mission Creep 100E part 64! Replacing the failed rear mount. [MEDIA]
Hello! Instead of one thread for each of my videos, I will put all the links in this one thread. Thanks for everyone that has followed along, I'll...
In part 62 of this epic saga: I always got the feeling the car felt reluctant to roll. I also thought it would turn in rather abruptly. I decided...
Yes, that's it. Join me for a ride on a sunny afternoon and witness years of grime being washed off the old 100E. Merry Christmas from me and...
In part 60 of this epic saga: I adapt a number plate lamp to replace the severely corroded original. I then coax the old vacuum wipers into action...
In part 59 of this epic saga: I fit new bulbs in the old British Pre focus headlamps and get the high and low beams synched. I then look at why...
The motor runs. The car drives. I fit new plates and start looking at the non charge issue. Another problem rears it's head though and it won't...
That could be made to work with reshaping the steering arm out towards the wheel and clocking the pitman arm outboard a bit. Trying to approach...
For those that have been following the repairs on the 100E. It was last used over 40 years ago. In part 57 of this epic saga: The motor runs. The...
In part 57 of this epic saga: I spend some time connecting up the lights and fit the rear bumper. I then decide to see if the engine will still...
Remember the caster angle is relative to the road surface rather than the vehicle. So correct tire sizes fitted front and rear, ride height set...
Separate names with a comma.