The Jalopy Journal
AG is still the best. As an owner of a 58 Plymouth, and a horror buff, I'm also a fan of Christine. Alright, alright, alright... When it comes...
The 4R70W is what replaced the AOD-E and is computer controlled. Its the same size as an AOD/AOD-E and has lower fist and second gear ratios: 1st...
Imperial Services makes a cable to use a later model trans with a push button shifter.
This comes as no surprise to me. After watching the winning bidder flip a coin to determine who would buy the car, I knew he was obviously...
Yes it will work, we did this for my brother-in-laws F1. You need the s-10 tail housing and top plate with the forks. You also need to find one...
I believe 50's Chrysler and Desoto were only available as 4 doors, where Dodge and Plymouth sold 2 and 4 doors.
Ford racing sells them. The other thing to do would be by a duraspark distributor for a 85 carbureted Mustang.
We are installing a T5 and 351w into my brother-in-law's F1. We swapped the mustang tail housing for one from a S10 T5 to move the shifter...
I insured my truck through State Farm. You may have to have a daily driver insured by them to insure your classic also.<?xml:namespace prefix = o...
I believe the popular denso swapped into mopars is from early 90's Toyota 4 runners. They are 60 amp with a 3 wire set up.
If your wanting something simple and compact look for rear ac units from SUVs and minivans. Most are ac only, small and have off and two or three...
[IMG]
You should be able to get plenty low by adjusting the torsion bars. You will just need to have the alignment redone once its lowered. For some...
I looked at all the pictures, but I never saw what vintage body you are putting on that donor chassis.
57,58,59 Mopars
I saw an article where the put them on a late model mustang. They measured quieter than stock at an idle and got loud when under throttle. There...
Texas law just changed, so now you have to register as an "antique" rather than a "classic" to use YOM plates. Before vehicles registered as...
Just show it to George Barris and he will claim he built it.:D
Cool, looks like something the Ramchargers would have built.
Explorer rears are suppose to be bolt in, if you want an axle flip. Otherwise you have to move the spring perches to the top of the axle. A lot...
You should find what you need by searching for your model gps and direct 12V. You should get something that wires directly into 12 volts and has...
I had a pair of those, actually "turbo tubes" with same strait through cambered design, on my truck. They were loud, I loved the way they...
Wheelkid makes something for that, look here:http://www.jalopyjournal.com/forum/showthread.php?t=263803
Yep, cheap bumpers form LMC run about $150 and "premium" bumpers go for around $200.
Those are the little car-like shapes that House of Kolor uses to as a sample of what their paint looks like on a car. It's easier to tell when...
Sounds like you'll have an entry for next Friday's art show.
You'll be pretty much limited to shorty or block huggers. Look for mustang header made for gt40p heads. Mac headers are reported to work with...
If it already has a 361 a 440 is basically a direct swap. They are both big blocks 440 just as a taller deck than a 361, so motor mounts should...
...and that's where funny cars come from.
Another thing you should consider, if you are using a Lokar kit, is a bracket to correct the cable travel on the carb side. Here is the one I...
Separate names with a comma.