The Jalopy Journal
Make sure to keep coolant away from pets.Keep it in covered containers and flush any that gets on the ground. Good luck.
If it made it to the pan, just leave it there and get a new drive shaft and install with the distributer. Good luck.
Save the duel quads for when you have more motor. The 360's pistons are too far down in the hole to really work well, especially in a heavy...
If the toe is correct, and the steering wheel is off center, you adjust both tierods so the road wheels turn toward the way the steering wheel is...
Nice video, Thanks.
Maybe You could buy a wishbone in the U.S. and have the seller cut off the yoke and ball and just send that,(cheaper shipping). Then you cut yours...
Really nice cars, Thanks
Way to go! Hometown Heros. Tom
[ATTACH]
The oil holes in the rocker shaft should be pointing down. Make sure the holes aren't galled shut. How much oil pressure? Use a drill to drive the...
Hi, I don't know,but if you check the points wire from the dist. to the coil, if that wire is connected to the positive side of the coil then it...
[ATTACH] [ATTACH]
I think with a governed engine,the accelerator pump would not be used. Don't know for sure though.
Mine,Ford FE[ATTACH]
Here would be good. You also could try the Ford barn. Pictures are always nice.
My fat bottom Gal.
The fuel pump arm, or lever is not aluminum. The eccentric that moves the arm is not aluminum. You will have to look yourself to see where the...
Nice job!
Time to pull the front cover.There is a mis-match of parts. Early and late timming sets,covers or thrust plates, can't quite remember,but I have...
A used(out of date) blow proof bell isn't very expensive and affords a lot more protection than a stock bell.
Can you turn the output easily when in neutral? Can you hear the noise then? Can you hold the output and turn the engine over by hand or with...
I hope you put oil in it! Without the driveshaft in oil should be running out,unless you have a plug or yoke in the output shaft. The slipyoke...
I have a 67 ford and the mounts for the ps pump are much smaller than what you have, They mount the pump up and closer to the water pump. Also...
Hi, I would call their tech line. 909-547-9058 Their web address is www.pertronix.com Hope this helps. Regards, Tom.
That should be ok with DOT 3 or 4. DOT5 (silicone) will expand quickly when heated and may cause the the brakes to drag or lock. Your probaly far...
Be carefull, the flywheel from a 64 f100 with the large spline input 3 speed will not fit in a pass bell.
Are you getting oil up there? You should tear it down to clean all the metal out. Measure the cam and eyeball the suspect lifters. Lots of things...
Hi, its been a long time, but try these numbers: Parts source-207-236-9791 and A.W. IMPORTS-800-392-6833. Those were for the easy stuff,but who...
Separate names with a comma.