The Jalopy Journal
pardon my butting in, the total timing is not important on a 350 in a pickup truck. that is for an engine that sees wide open throttle a majority...
this is just my opinion, 14 degrees base timing may be a little much, try 8 to 10, you most likely will not need to do anything else. with the...
I would like a pair for my 364, kinda found of satin finish
does your valve cover have a baffle under the pcv valve? if not it will use a bunch of oil, the pics of your short block look like all the...
[ATTACH] [ATTACH]
the difference is on the drive end, it is longer between the three bolt flange face and the the end of the drive end housing the armature is...
this looks interesting, 66 looks great also
there was one[ATTACH] for sale a year or two ago at the Chicksha OK swap meet. it was a little rough, i took some pictures
it is rebuilt stock, I would like to shave the head and do a cam swap before installing. i really like the looks of the 1x2 wearing their two...
I recently acquired a 1950 Chevy style line two door, I bought a 1959 235 already rebuilt and have a T5 to go behind it. my question is this, is...
purchased four boxes of hose clamps a few weeks back, they all stripped when hand tightening with a nut driver as soon as all the slack was gone
you changed the intake manifold right? did you use the intake gasket set for the tbi engine? if so they could be on backwards, the stock tbi...
check out Delta Current Control, they build a simple to install pulse width modulated system of controlling the fan. by turning on and off the...
that isn't a very good way to wire it, when shut off the fan will become a generator and the engine will not shut off till the fan stops rotating...
i have a complete slant pan hydra-metic for a Pontiac with the bell housing and flywheel i would like to move, pm me if you have an interest i...
[ATTACH]
edelbrock sells an adapter that bolts over the open choke stove port, it has a pad your choke will mount to
try inliners international and clifford 6=8
failures of most ignition control modules can be traced to a bad coil, the windings short out allowing to much current to pass through the...
i saw that on a show in the 1960's it had Walter Cronkite as the host, he put his index fingers in those small holes to steer the car. i think the...
i bought a 348 a few years ago off of craigslist, i rebuilt the lower end stock bore with a small bit of wear, crank was standard. the rings i...
i have a 1 ton 1955 gmc 288 which is just a 287 pontiac, it is a running driving truck. i plan on changing the engine if you are interested
is it just me? the basic function of a brake is turn forward motion into heat and dissipate it into the air, vented rotors pump air like a...
if you look closely at that cover pic the ports are not reversed, he moved the intake ports to the outside of the head
go to a local alternator shop, i had built for a tractor, one wire gm. it just takes a special regulator form what i remember, cost was under $100...
if it has an aluminum front pump, they were known for the front pump bushing walking forward and pushing the seal out. it can be repaired, the fix...
if the crank pulley has two different diameters, the water pump pulley has to have them as well, thats causing the belt squealing in the video
the crank pulley does not match the water pulley, the crank pulley has a different diameter between the alternator and the power steering grooves,...
the short answer is yes, but the outlets don't hug the block as closely as the older models and may interfere with the chassis. there is an egr...
i have a 478 v6 and a 702 v12, hope have both of them running one day, check out where the pcv valve is located. there is one on each head it...
Separate names with a comma.