The Jalopy Journal
You guys rock. Thank you for the wealth of information. I have a 72 390 with 428cj heads in a 54 f100 with mustang II IFS and it has been a...
Thank you guys very much. I was racking my brain trying to find something that would work. Posted using the Full Custom H.A.M.B. App!
Can anyone tell me if the 428 cobra jet heads and the 390 fe heads are interchangeable as far as headers go? Posted using the Full Custom...
Thanks for the replies guys. I am skeptical of the shaved handles but I am going to try and mount the emergency cable somewhere I can access...
It doesn't wear the sheathing out opening and closing the door all the time?
My Effie has shaved door handles, and I am curious about emergency cables. I was just trying to get some ideas at to where people have mounted...
That is the only think I could thing of, since they had carrier bearings.
[ATTACH] If anyone can help me ID this. It's an fe c6 trans but I have not seen this style tail shaft before. I don't think it's 4wd but I could...
I know it. I will search again but I didn't find much about starting from scratch. I appreciate any insight. Posted using the Full Custom...
I understand this is not a rat rod site. All I am looking for technical assistance with building doors.
Has anyone every tried building their own doors for their rat rod? I am talking about building the frames, skins everything. I know it would...
Thank you very much for the replies. Posted using the Full Custom H.A.M.B. App!
I have a 2003 mustang gt hydro and master. From the research I did it should work without any issues. As far as the junction that makes sense. It...
I had looked into that and thought that to be a good idea as well. Posted using the Full Custom H.A.M.B. App!
I have made mention of my brakes in the past and am just looking for some insight I'm not looking for opinions on go back to vacuum assist brakes....
It is not a matter of necessity for because of engine power. It's just an issue of room in the engine compartment. In regards to my calipers I'm...
Is anyone using hydro boost? Curious about limitations and adaptability. I have a 54 f100 and have access to a 2003 mustang hydro boost and...
All I needed was to know about the plates that the rubber mounts rest on for the front mounts. Those pictures worked perfect thank you
I'm finally getting my cab finished up and the front body mounts are completely gone can anyone tell me all the parts needed to completely finish...
I am stripping my 54 F100 down to bare metal. There is silicone that runs in along the roof on the outside, does anyone know what I cane use to...
Well I changed my engine setup. I just purchased a 454 block, picked up a forged 427 crank, dome top pistons and eagle rods. So if anyone needs a...
I may have messed up during the rebuild of my 9 inch. I got her all stripped down and am finally going back together. The problem I have ran into...
I have a whole mess of photos from the parade. I will try and get them loaded.
I will be there to check out the rides. Unfortunately the pickup wont be done. My goal is to have it ready for next year
The front end was much easier then the four link in my opinion. Set it at a 5 degree rake. [IMG] [IMG] [IMG] [IMG] [IMG]
Awesome thanks guys, I really would like to keep this engine setup.
I currently have a 402 BBC, but have found that piston options are very limited. I would like to know if anyone else had built one of these and if...
It's nice to see more people on here from Kansas and close to the area.
Got the four link done, and got her C sectioned :D [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
Im hoping to get a nice wide stance out of her. All the parts for the four link showed up today, I should get started on it Thursday morning. I...
Separate names with a comma.