The Jalopy Journal
DAM Olds are tanks better yet UAV's "Urban Assault Vehicles"!
3B or 3200 series 122.3 wheel base (8 foot bed) 1/2 ton, the 56 year, O means Oakland Ca, 18,164 production number
The fan shroud turn side ways fits a 32 radiator shell just got to swap the motor on fan with standard GM fan pull type instead of push type.
Ever thought of buying another? http://www.speedwaymotors.com/Universal-Master-Cylinder-Pushrod-5-5-8-Sleeve-3-8-Heim,9329.html...
If you don't get an answer try asking here a lot of bagged clips in build section of sub forum....
Get some small exhaust tubing split it down the middle, use two house clamps at each end stretch the spring, and tighten the clamps. Then install...
You should make a new guy introduction before you get slammed on the forum. I agree that steering box looks like a clipped front end and no it...
Me & the Wife in Mexico our HD, Pic was posted in easyrider magazine, look ma I am famous!:D
I could use one for either poroject:)
I used KYB schocks made for a 66 Ford Econoline van and cut original shock bracket and welded the brackets on to the spring clamp sorry for the...
Does mine qualify?
Here is where you can find bearing same as 72 truck tilt Lower Bearing, # 34-0847, (LMC) $19.95 Lower Bearing Retainer...
That is a nice Willy's congrats my Uncle has two 392 Hemi's in storage I can ask if he wants to part with them.
Wise choice plus the vettes with the steal bumpers are getting hard to find and collectable!
Beautiful work as always, thanks for saving someone's life especially my family that drive in Phoenix!
Like said before it is cheaper to remove at the platers than re-chrome . I had an axle that chrome was shot. Total for removal was $30 dollars.
The air lines was the week point for that set up in the sixties it was prone to leaks. They weren't designed for up and down usage. Compared to...
VIN is located on door driverside post and top of frame near near original steering box location write down numbers and have DMV run them and hope...
I dont think thats a camaro clip
Wax em
Good stuff Jesse, Best of luck on show. I just hope you threw in a old school knuckle or panhead build once in a while for us old bikers, I loath...
Ask question here a lot of info http://67-72chevytrucks.com/vboard/forumdisplay.php?f=13
Stock Cam
Forgot to add if you want more info on your style truck go here a lot of good folks like here...
If you want five lug to match the rear 49-54 Chevy hubs and brakes will work on your spindles
Should be the same as rear depending if it is 15 inch or 16 inch rims. I think normally on a six inch wide rim would be around 3 3/4 to 4 inches
I agree O.E.M looks good!
Also hydro would work beter with independent fronts
Hydros on front leafs are not really going to work good, a lot of fab, did you ever think of clipping truck and using bags? Go to this site a...
Thank you to all who replied I really appreciate everyones advice!:D
Separate names with a comma.